oalogo2  

AUTHOR(S): 

Waldemar Mironiuk

 

TITLE

Influence of Flooding Boat Deck Ship Compartment on the Changing of a Righting Lever as a Sea Safety

pdf PDF htmlFULL-TEXT HTML

 

ABSTRACT

The paper contains the computational stability issues with high flooded ship compartment on the boat deck. Defined righting lever calculation algorithm with the free surface effect after flooding high located ship compartments was taking into account. Based on results of the calculations presented in the graphical form suitable conclusions were done.

 

KEYWORDS

ship stability, angle of heel, safety of warship

 

1 Introduction

As Ship is a compound technical system operated intensively in particular during military activities. Her combat abilities depend, first of all, on munitions with which the vessel is equipped and on the remaining technical measures ensuring her way [5]. Damages caused to those measures result in deterioration of the boat military capabilities and they may be followed by various reasons. Fire presents serious hazard to a ship when at sea. It results in her sinking rarely, however the left devastation is usually very serious and, as ever, depending on the level of the crew training in respect to the damage control plan. During peaceful operation of the combat vessel, short-circuits in electrical installations, failures of devices and mechanisms, self ignition of pure oxygen when contacted with petroleum materials and so on make most sources of fires. Seawater is usually the main extinguishing agent used on ships and high volumes of the water are hazardous to the vessel stability and subdivision. Therefore, in the paper, the main emphasis has been made on defining the impact of high located and flooded compartments on the ship stability safety. Results of calculations presented in the elaboration contain information regarding volumes of water in the compartment causing deterioration of the ship stability.

 

2 R esearch object characteristics

The training vessel selected for the tests is a flagship of the training and research ships’ wing of our fleet. The said boat is divided, with ten transverse watertight bulkheads, into 11 watertight compartments located on the frames: 3, 16, 25, 35, 50, 60, 71, 80, 91 and 101. Such division ensures maintenance of unsinkability when two neighbouring compartments have been flooded, excluding main engine room and adjoining compartment. Analysis of the damage stability after flooding high located compartments has been justified because the ship sails in different sea waters, so in various and dangerous weather conditions where the risk of damages is high. General characteristics of the vessel:

- main dimensions:

overall length: Lc = 72,20 m,

length between perpendiculars: Lpp = L = 64,20 m,

maximal breath: Bmax = 12,00 m,

breath: B = 11,60 m,

height: H = 5,55 m.

The calculations have been made for load displacement and no icing.

Fig. 1. Picture of the training vessel [9]

These conditions are characterized by the following quantities:

- displacement: D = 1745,34 t,

- ordinate of the mass centre from the main plane: zG = 4,31 m,

- stern draft: TR = 3,97 m,

- bow draft : TD = 4,05 m,

- average draft: Tśr = 4,01 m,

- trim: t = 0,08 m,

- metacentr height from the main plane: zM = 5,44 m,

- metacentric height: GM = 1,13 m,

- speed: V =16,8 w

- coordinates of the mass centre:

§ xG = 29,649 m from the after perpendicular,

§ yG = -0,007 m from the plane of symmetry,

§ zG = 4,314 m from the main plane [9].

 

3 Defining the metacentric height and the righting levers of the ship

Water broken into the vessel’s hull and the flooded compartment or tank result in deeper draught of the ship, possible heel and trim as well as a change in her stability. The change may improve or aggravate operational conditions of the boat. In some case, lower stability may be serious enough to endanger safety of the ship and her crew as well as it may cause overturning of the vessel. To avoid accidents of such a kind, it is necessary to check stability of the damaged ship and apply appropriate remedial measures that would stop its lessening.

Flooding of high situated compartment or several compartments always results in aggravation of the vessel’s stability. As a consequence, a heel or trim of the ship, change in the metacentric height and the righting levers may occur.

A vessel of standard displacement D for which a mass m is loaded in the point A (X, Y, Z) as in the Figure 2 [1,2,3] has been taken into consideration in the stability calculations.

Fig. 2. Scheme of the ship situation after acceptance of the mass m in the point A [1,2,3]

At the beginning, acceptance of the mass was assumed so that to have its centre vertically above the centre of water-plane section’s surface WO in the point A1 (XS, 0, Z). Then, it is possible to calculate [1,2,3]:

- the draught increase, as per the formula:

(1)

- the new transverse metacentric height, as per the formula:

(2)

- the new longitudinal metacentric height, as per the formula:

(3)

In the next step, the mass was moved from the imaginary position onto the place occupied in reality:

- towards the transverse direction by a distance of e = Y-Y1 = Y-0 = Y, e = Y-Y1 = Y-0 = Y,

- towards the transverse direction by a distance of l = X-XS. l = X-XS.

The angle of heel of the ship has been calculated with the below formula:

(4)

and the trim of the vessel from:

(5)

The new draughts of the bow and stern are defined from the following equations:

(6)

(7)

The final results are as follows:

(8)

(9)

For large angles of heel (above 7°), the ship stability is defined based on the righting lever curves (Reed’s curve). This curve allows determining dimensions of the righting lever for any angle of heel of the given ship, at invariable displacement and position of the mass centre.

Value of the righting lever is determined with the following formula applied [14]:

(10)

where:

(11)

Zg - the mass centre height [m],

- the weight stability lever [m],

- the form stability lever [m].

Fig. 3. Righting lever of the shape and mass [1]

The formula (10) may be presented in the following way:

(12)

For the determination of the righting lever for any angle of heel it is necessary to know the form stability lever that changes depending on the angle of heel. This value is read from the so-called Pantecaren graph, which is developed during the design phase of the ship.

Reed’s curve which is a graph of righting levers provides information about the basic parameters of the stability of the ship, such as:

φ Gzmax - heeling angle at the maximum value of

the righting lever occurs [deg],
GZmax - the maximum righting lever [m],
φr - the angle of vanishing stability [deg],
GM - the metacentric height [m].

 

4 F ree surface effect

Presence of fluid free surface effect after partial flooding of compartment always results in reduction of the vessel’s metacentric height. This decrease depends, among the others, on the shape and magnitude of this surface.

Receipt of liquid cargo on board of a ship, accompanied by occurrence of the free surface, has influence on change of position of the vessel mass centre and thus on the metacentric height . Hence usage of, for instance, larger quantities of water for fire-fighting purposes on upper decks results in shifting the boat’s mass centre up, and – if connected with occurrence of free surfaces – it may cause the loss of stability and overturning of the ship.

Impact of inertia moment derived from the free surface of the flooded compartment has been taken into account in the calculations of the metacentric height. It has been assumed that surface of the compartment under flooding is rectangular. The moments of inertia of the permanent constructional elements present in the compartment have been taken into consideration in calculations regarding the inertia moment of the entire body.

Influence of the fluid free surface on the righting levers’ curve (the Reed’s curve) has been taken into account by implementing an allowance marked with an X symbol X[1,2,3].

(13)

where:

and - constituents of shift of the vessel’s mass centre, at the heel to the angle φ[m],

(14)

(15)

D – ship displacement together with liquid cargo [t],

mi mass of the liquid cargos in particular tanks [t],

and constituents of shifts of the fluid mass centres in the flooded compartments at the heel to the angle φ [m] [10]. These parameters have been calculated with a used of an elaborated computer programme. This software is adapted to calculate stability parameters for a floating structure of rectangular shape.

After defining the allowance from the fluid free surface, the new GM is:

(16)

Based on the formula 16, the calculations and analyses of the vessel’s metacentric height after flooding the ship compartment have been made.

5 Results of the vessel stability with a ship compartment flooded

The calculations have been made for a compartment located at the height of 8,10 m from the main plane. This compartment, of the dimensions: width 8,67 m and length 36,78 m, is represented by a plane surface, after considering its equipment, equal 188,5 m2. It was undergone flooding up to the water height H previously assumed.

The results of the righting levers calculations, with the free surface effect, for the considered water heights in the compartment, was taken into consideration. A course of changes of the righting levers’ curve (the Reed’s curve) versus the heel angle of the ship is presented in the Figure 4. The angles of steady heel of the ship, resulting from flooding of the vessel compartment under discussion, amount respectively: φS1 = 12° for the water level in the compartment equal H = 1,0 m and φ S2 = 18° for H = 1,6 m. The metacentric heights for these cases display negative values.

water level – beginning

water level – H=0,1m

water level – H=0,4m

water level – H=0,8m

water level – H=1,2m

water level – H=1,6

Fig. 4. Influence of the amount of water in the compartment on the Reed’s curve

For the amount of water in the compartments H = 1.6 m angle range of righting lever reduced from approx. φr = 100º to approx. φr = 60 °.

 

4 Conclusion

As a result of analysis of the ship’s stability after flooding a high situated compartment provides the following conclusions:

Flooding of high located compartment results in:

- a reduction in a value of metacentric height,

- a reduction in a value of righting levers,

- a reduction in the angle range righting lever φr,

- an increase in a value of steady heel angle φS.

The analysis of changes in the stability of the ship shows, that the worst option is the simultaneous flooding of two compartments have to height H = 1.2 m. It causes a loss of initial stability of the ship. The recovery of stability followed by an inclination of the ship equal φs = 12 °.

 

REFERENCES

[1] Kabaciński J.: Stateczność i niezatapialność statku, Gdańsk 1995.

[2] Derett D. R.: Ship stability for Masters and Mates, BH. Oxford,UK,2003.

[3] Dudziak J.: Teoria okrętu, Wydawnictwo Morskie, Gdańsk 2006.

[4] Jacyna M.¸ Wasiak M, Lewczuk K., Michał Kłodawski M.: Simulation model of transport system of Poland as a tool for developing sustainable transport, Archives of Transport - Archiwum Transportu - No 3/2014 vol. 31 Warszawa 2014.

[5] Jakus B., Korczewski Z., Mironiuk W., Szyszka J., Wróbel R.: Obrona przeciwawaryjna okrętu, cz.1, Gdynia 2001.

[6] Mironiuk W.: Preliminary research on stability of warship models, COPPE Brazil, Rio de Janeiro, 2006.

[7] Mironiuk, W., Pawlędzio, A., Wróbel, R. Trenażer do walki z wodą. Przegląd Morski nr 5 Gdynia 2004.

[8] Mironiuk W., Pawlędzio A., Wróbel R.: Analiza stateczności statycznej pontonu prostopadłościennego o wymiarach LxBxH. Zeszyty naukowe AMW. Gdynia 2004.

[9] Mironiuk W., Pawlędzio A., Zacharewicz M.: Badania modelowe stateczności i niezatapialności okrętów. AMW Gdynia 2006.

[10] Mironiuk W., Pawlędzio A.: Modelling studies of the roll and the pitch training ship. Maritime Transport & Shiping, London, UK, 2013

[11] Przepisy klasyfikacji i budowy okrętów wojennych. Część IV, Stateczność i niezatapialność. Polski Rejestr Statków, Gdańsk 2008.

[12] Szozda Z.: Stateczność statku morskiego. Akademia Morska, Szczecin 2004.

[13] Więckiewicz W.: Podstawy pływalności i stateczności statków handlowych. AMG, Gdynia 2006.

 

Cite this paper

Waldemar Mironiuk. (2017) Influence of Flooding Boat Deck Ship Compartment on the Changing of a Righting Lever as a Sea Safety. International Journal of Applied Physics, 2, 46-50

 

cc.png
Copyright © 2017 Author(s) retain the copyright of this article.
This article is published under the terms of the Creative Commons Attribution License 4.0