TITLE

An approach to the Influence of Fluid Viscosity and the Cutting Parameters in Turning a Carbon Steel Using Surface Methodology

pdf PDF

ABSTRACT

This experimental study focuses on the effect of viscosity on the surface condition of machined parts during turning. The tests are carried out on C45 steel, using metal carbide cutting tools. The objective is to optimize the cutting parameters as well as the analysis of the surface roughness (Ra), using the surface response method, which allows to present the mathematical models of the roughness. The effect of the interactions on the roughness criterion was studied using a statistical analysis based on analysis of variance (ANOVA). The results recorded show that the cutting speed has the most significant effect on the surface condition. This optimization deduces that the best surface roughness of the non-alloy steel parts C45 is obtained when the cutting speed is 286 m / min, the feed rate is 0,15 mm / rev, the viscosity is 22,5 Pa.s and the depth of cut is 1,1 mm.

KEYWORDS

Turning, viscosity, roughness, cutting conditions, ANOVA, optimization

 

Cite this paper

Kamel Bousnina, Ali Falleh. (2021) An approach to the Influence of Fluid Viscosity and the Cutting Parameters in Turning a Carbon Steel Using Surface Methodology. International Journal of Mechanical Engineering, 6, 18-24

 

cc.png
Copyright © 2021 Author(s) retain the copyright of this article.
This article is published under the terms of the Creative Commons Attribution License 4.0